Table of Contents
Advertisement
Operating modes
10.13 Option: Concentrate tank empty signal
10.14 Option: Booster pump
10.15 Option: Modbus/Profibus/Profinet data communication
78
Ä Chapter 6.3.3 'Option: Empty signal for con‐
Technical data, see
centrate tank' on page 44 and Ä Chapter 11.3 'Setting the liquid
concentrate empty signal sensor' on page 82 .
Ä Chapter 6.3.4 'Option: Booster pump'
Technical data, see
on page 45 and Ä Chapter 9.6 'Control' on page 60 .
This option should be selected for installations with low raw water
pressure.
The booster pump is fed with supply voltage from the control cab‐
inet and is automatically controlled via the HMI.
Settings are not required, the setpoint is pre-set at 3.0 bar.
Stop of production from HMI!
MENU: SYSTEM
Login
Conc:
Capac.: l/h
Input of control data - WD / PAUSE / Reset / SETPOINTS
Bar
OFF
Fig. 50: Data communication
Various types of data communication are available depending on
the identity code selection.
0 – no communication
n
1 – Modbus TCP/IP communication
n
2 – ProFibus DP communication
n
3 – ProFinet communication
n
Once one of these communication methods has been selected, the
additional "Communication" sub-menu is displayed in the "System"
tab
The following functionality can then be selected:
"Read"-only of operating conditions, faults,...
n
"Send and write data"
n
–
External pause
–
Error reset
–
Concentration in %
–
System capacity in l/h
Separate supplementary operating instructions are available for
this purpose, which will describe in detail the set-up of the data
communication on the system and the customer's connection.
SUBMENU: Commun. Interface
Profibus settings
Control words - Inputs enables
ARCHIVES
A3633
RESET
Advertisement
Table of Contents
