Table of Contents
Advertisement
Operating modes
10
Operating modes
10.1
HMI pre-settings
Concentration
Active ingredient
The raw water flow produces the
system output with an inline
system
Pressure in the system
10.2
Overview
Operating mode
MANUAL
AUTO
OFF
68
0.5%
typical value, currently max. 1%, 1.5% is technically
possible
50%
conventional emulsions
the max. system configuration value is set at
delivery. Please note the minimum flow.
400 l/h
without post-dilution
1800 l/h
with post-dilution / current value
6.0 bar
max. value
Overview:
AUTO
n
MANUAL
n
OFF
n
AUTO
n
The operating mode is selected by pressing the field on the HMI. It
can be found in the lower left corner of the HMI. 3 operating modes
are available. The bottom line displays the most recent active oper‐
ating mode, in this case
Function
The pump, valves and stirrer etc. can be tested to ensure that they are
working properly
Start-up, procedure depending on the type of system
Polymer preparation
Stops the functions of the system
Start-up, pre-condition or activity
[AUTO] .
Advertisement
Table of Contents
