Panasonic KX-TDA50 Features Manual page 307

Q If I reset the PBX directly after modifying settings, the modified settings are not
updated in the PBX.
A • When you click Apply, the settings are updated in the PBX, but are not yet saved to the
SD memory card. If system data is not saved to the SD memory card, the PBX will restore
the data that was last saved to the card in the event that the PBX is reset, or power is
turned off and back on again.
Therefore, before resetting the PBX, click the SD memory backup icon to save the
system data to the SD memory card. Alternatively, exit the Maintenance Console. This
automatically saves system data to the SD memory card.
Note
Do not remove the SD memory card during access. Doing so may result in failure to back
up data correctly.
Q After reinitializing the PBX, I restored system data from a previous backup.
However, some of the settings have not been restored to their previous values.
A • The following setting data is not saved to the SD memory card, so will be deleted when
the PBX is initialized. This data is stored in the PBX's battery backup memory.
• Present Button Status of extension FWD/DND
• Status of Group FWD
• Call logs
• Status of Station Lock
• Status of Login
Q Not all of the characters of a setting can be displayed because the column is
too narrow.
A • Move the mouse to the line between the names of 2 setting items, at the top of the table.
The pointer should change to a double arrow. Click and drag the line to the right until all
characters are displayed.
Q How do I set card status to "INS"?
A • In the Configuration—Slot screen (see "4.7.1 Slot [1-1]"), click the Status cell of the
card, and select "INS".
Q How do I set card status to "OUS"?
A • In the Configuration—Slot screen (see "4.7.1 Slot [1-1]"), click the Status cell of the
card, and select "OUS".
Q The status of a new card will not change to "INS".
A • With the new card installed, does the total number of extensions or CO lines exceed the
maximum supported by the PBX?
• Is the type of card installed in the slot different from the card type set as "Pre-INS" for that
slot? Confirm that the correct card is installed in the slot.
• Is the card firmly and fully installed in the slot? Confirm that the card is installed correctly
in the slot.
• Confirm that the card is not damaged.
Q I want to set the status of only 1 port of the IP-GW4 card to "OUS".
4.6 Help
Feature Guide 307