Installing Sfp Modules In The At-X510-28Gsx And At-X510-28Gsx-80 Switches; Figure 22: Removing The Dust Plug From An Sfp Slot - Allied Telesis AT-x510-28GPX Installation Manual

Allied telesis x510 series gigabit ethernet switches

Hide thumbs Also See for AT-x510-28GPX:

Table of Contents

Installing SFP

Modules in the

AT-x510-28GSX

and

AT-x510-28GSX-

80 Switches

To install SFP transceivers in slots 1 to 24 of the AT-x510-28GSX or

AT-x510-28GSX-80 Switches, perform the following procedure:

1. Remove the dust plug from a transceiver slot on the switch. Refer to

Figure 22.

Figure 22. Removing the Dust Plug from an SFP Slot

2. Remove the transceiver from its shipping container and store the

packaging material in a safe location.

3. If you are installing the transceiver in a top slot, position the transceiver

with the Allied Telesis label facing up. If you are installing the

transceiver in a bottom slot, position the transceiver with the label

facing down.

4. Slide the transceiver into the slot until it clicks into place, as shown in

Figure 23 on page 68.

x510 Series Installation Guide for Stand-alone Switches

Table of Contents