Installing Conditioner - MacDon R113 Unloading And Assembly Instructions

4.2 Installing Conditioner

The conditioner is very heavy. Installing it will require the use of a forklift or equivalent lifting device.
1. Attach spreader bar (A) to the forklift (or an equivalent
lifting device) and attach chains to lugs (B) on the
conditioner. Use a chain rated for overhead lifting with a
minimum working load of 1135 kg (2500 lb.).
WARNING
Ensure that the spreader bar is secured to the forks so that it
cannot slide off the forks or towards the header while you are
attaching the conditioner to the header. Failure to do so could
result in death or serious injury.
2. Lift conditioner (C) and align it with the header opening.
3. Carefully align pin (B) at each end of conditioner (A) with
lug (C) on the header. Lower conditioner (A) until pins (B)
engage lugs (C) on the header. Avoid contact between the
top of the conditioner and the center-link anchor.
4. Align the mounting holes and install four M16 x 40 hex
head bolts (A) with the heads facing inboard (two per side).
Secure the bolts with four M16 center lock flanged nuts. Do
NOT tighten the nuts yet.
262300
CHANGING CONDITIONER
Figure 4.14: Lifting Conditioner
Figure 4.15: Installing Conditioner
Figure 4.16: Left Side of Conditioner – Right Side
Similar
26
A
B
A
C
B
A
B
C
Revision A