Chapter 2: Unloading Header - MacDon R113 Unloading And Assembly Instructions

Chapter 2: Unloading Header

To unload the header from the trailer safely and without damage, understand the weights and lifting requirements and
familiarize yourself with the procedure.
CAUTION
To avoid injury to bystanders from being struck by machinery, do NOT allow people to stand in unloading area.
CAUTION
Equipment used for unloading must meet or exceed the requirements specified below. Using inadequate equipment
may result in chain breakage, vehicle tipping, or machine damage.
Table 2.1 Lifting Vehicle
Minimum Capacity 1
Minimum Fork Length
IMPORTANT:
Forklifts are normally rated for a load located 610 mm (24 in.) ahead of the back end of the forks. To obtain the forklift
capacity at 1220 mm (48 in.), check with your forklift distributor.
IMPORTANT:
Do NOT lift at hooks (A) when unloading from the trailer.
Hooks (A) are ONLY for tipping the machine over to working
position.
WARNING
Be sure forks are secure before moving away from load. Stand clear when lifting.
1. At 1220 mm (48 in.) from back end of forks.
262300
3630 kg (8000 lb.)
198 cm (78 in.)
A
Figure 2.1: Lifting Header off Trailer
9
Revision A