Attaching Header - Hydraulic Center-Link Without Self-Alignment - MacDon R113 Unloading And Assembly Instructions

5.4 Attaching Header – Hydraulic Center-Link without Self-Alignment
The header will need to be physically attached to the windrower, and the hydraulic and electrical connections completed. If
the windrower is equipped with a hydraulic center-link that lacks the self-alignment capability, the Operator will have to
manually attach the hydraulic center-link's hook to the header's center pin.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator's seat, and always engage the safety props before going under the
machine for any reason.
1. Shut down the engine, and remove the key from the ignition.
2. Locate header supports (A) on the rear of the header.
3. Remove hairpin (B) from clevis pin (A), and then remove
the clevis pin from header support (C) on both sides of the
header.
262300
ATTACHING ROTARY DISC HEADER TO WINDROWER
56
Figure 5.45: Header Supports
Figure 5.46: Header Support
A
C
B
A
Revision A