Connecting Header Hydraulic And Electrical Systems - M1170 Windrower - MacDon R113 Unloading And Assembly Instructions

6.4 Connecting Header Hydraulic and Electrical Systems – M1170
Windrower
IMPORTANT:
To prevent contamination of the hydraulic system, use a clean rag to remove dirt and moisture from all (fixed and
movable) hydraulic couplers.
1. Open the platform. For instructions, refer to the windrower
operator's manual.
2. Retrieve the hydraulic hoses from the header.
3. Attach hose support (A) to the frame near the windrower
left cab-forward leg, and route the hoses under the frame.
NOTE:
Route the hydraulic hoses as straight as possible, and avoid
rub/wear points that could cause damage.
4. Disconnect male coupler (A) from the pressure hose.
5. Disconnect female coupler and fitting (B) from the
return hose.
262300
ATTACHING HYDRAULIC AND ELECTRICAL COMPONENTS
Figure 6.62: Hose Support Attachment
B
Figure 6.63: Hoses from Header
89
A
A
Revision A