Table of Contents
Advertisement
5.10.4 Auto EQ
Auto EQ:
ON
Press ENTER to accept the selection made.
Press CLEAR to retain the original value.
5.10.5 Fast Charge SOC Limit
The charger can be configured to allow fast charging of batteries only up to a fixed percentage.
This percentage of battery state of charge is calculated when the battery is first connected to
the charger and is updated as the charging progresses. If a battery is charged up to this limit
and is not scheduled to full charge or equalize, the charging is stopped. If the charger is
configured for full charging or equalizing during this period, charging will proceed past this SOC
limit as the charger enters the full charge or equalization state.
This fast charge limit is also used in conjunction with the BMID programmed fast charge limit.
The lower of these two parameters are used to terminate a fast charge session. This parameter
can be set to 100% to allow only the BMID SOC limit to be the limiting point. If backup battery
(or ultra-cap) power is lost, this parameter will need to be review and/or updated, as it will be set
to a default value in this case.
Fast Charge SOC
Limit
Use the UP and DOWN arrow buttons to set the parameter to the appropriate value.
Press ENTER again to accept the selection made.
Press CLEAR to retain the original value
5.10.5.1
Setting the Fast Charge SOC Limit
From the "Fast Charge SOC Limit" screen press <enter> to display the active Fast Charge SOC
Limit setting. Press <enter> again and the adjustable parameter will flash. Use the <up> and
<down> buttons to adjust the SOC limit. Once the desired limit is displayed, press <enter> to
store the edited value and the display will stop flashing. Press <clear> to exit.
23435-W-03-01
SVS100 Installation, Operation and Maintenance Manual
ENTER
Auto EQ:
OFF
Figure 5- 14 Auto EQ Menu
CLEAR
ENTER
Figure 5- 15 Fast Charge SOC Limit Screens
37
Charger Configuration
CLEAR
Charger Configuration
Fast Chrg SOC Limit:
100%
Webasto Charging Systems, Inc.
Advertisement
Table of Contents
