Table of Contents
Advertisement
1.
Charging data. This screen displays the voltage, current, state-of-charge, and
temperature of the battery. During a charge, the screen will say "Charging" and the data
will be updated periodically.
2.
Charge start data. This screen shows the charge start date & time, as well as the voltage,
state of charge, and temperature of the battery when charging started.
3.
Charge time and Amp-hours. This screen shows how long the battery has been under
charge and how many ampere-hours have been returned to the battery. During charging,
this data is updated periodically. After a charge is complete or stopped by the user, this
screen retains the final charge time and amp-hour values.
4.
Battery type. This screen shows the Type code programmed into the BMID, along with a
description of that type.
5.
Battery configuration. This screen shows the other battery configuration information
programmed into the BMID: identification number, number of cells, capacity, and voltage.
6.
Charger Configuration. This screen shows the charger model number and software
version.
7.
Date & Time. This screen shows the current date and time.
8.
Fault Description. If there is an active fault or warning, the fault or warning code and
description are displayed. See Section 5.5 for further information on Faults and
Warnings.
5.6
Fault and Warning Screens
Fault/Warning Screens
In the event of a fault or a warning, a fault/warning screen will appear automatically (see Figure
5- 5). The other screens shown above remain available through use of the up & down arrow
buttons. If there is more than one fault or warning, there will be a screen for each one. The
fault/warning screen shows an assigned fault number and the name, which indicates the type of
fault or warning. Check Table 6- 1
complete listing of faults and warnings.
The Fault/Warning Log data screens (see Figure 5- 6) allow the user to review the data from the
last 50 fault or warning events in the charger. These data are stored in the charger and are
preserved even if power is cut and restored to the charger.
1. Event ID screen - Shows the active (most recent) fault or warning event. Using the UP and
DOWN arrow keys, scroll through the last 50 fault or warning events. For each fault or
warning event, the date and time will be recorded to help locate a particular event. Once the
desired event is displayed, press ENTER to open the log for that event. At any point in the
log file press CLEAR to return to the Event ID screen.
2. Fault/Warning Code - Shows the fault code and the name of the selected fault or warning
event. See Tables 8.1 and 8.2 for explanation of the faults and warnings.
3. Clearance Date - Shows the date and time that the fault was cleared.
Pre-fault State - Shows the state of the charger when the fault or warning occurred. Either
4.
"Charging battery XXXXXXXX" or "Idle".
23435-W-03-01
SVS100 Installation, Operation and Maintenance Manual
and Table 6- 2 in the troubleshooting guide for a
Figure 5- 5 Fault or Warning Screens
26
Webasto Charging Systems, Inc.
Advertisement
Table of Contents
