Basic Workflow - Barco CX-50 Gen2 Installation Manual

Change the default Configurator password
Barco strongly recommends changing the default Configurator password. Anyone with malicious intentions
who can access the Base Unit locally or via adjacent networks will definitely verify if the Base Unit's
Configurator can be accessed to extract valuable information like e.g. Wi-Fi credentials.

3.3 Basic Workflow

Before using CX-50 Gen2
1. Unpack the ClickShare components and accessories from the box.
For a detailed overview of the content of the CX-50 Gen2 box, see
2. Install the Base Unit in the meeting room using one of the 2 possible installation methods.
For more information on the installing procedures, see
3. Connect the display with the the Base Unit via HDMI or the backside USB Type-C
connection to the Base Unit", page
4. Connect the audio devices via USB or jack, if any to the Base Unit, see
Camera only conference room", page 38
5. Connect the USB camera to Base Unit if any, see
room", page 38 or see
6. Make the power connection via the power adapter or the backside USB Type-C
connection", page 43.
7. Connect a network cable between the Base Unit and the local network (make sure the Base Unit is
connected to the internet to be able to reach the update server )
8. Configure device.
9. Register you device online to obtain your SmartCare package.
10. Pair your Buttons, see
37.
or see "Content Audio
"Camera connection", page
"Preparing the Buttons", page 59
"About the Base Unit", page
"Fully equipped, Audio only or
connection",
"Fully equipped, Audio only or Camera only conference
40.
and/or install the ClickShare app.
R5900120 /01
Getting started
21.
TM port, see "Display
page 40.
TM port, see "Power
CX-50 Gen2 27