Environmental Condition Check; Basic Workflow - Barco CX-50 Installation Manual

Getting started

3.1 Environmental Condition Check

Environment condition check
For installations in environments where the device is subject to excessive dust, then it is highly advisable and
desirable to have this dust removed prior to it reaching the device clean air supply. Devices or structures to
extract or shield excessive dust well away from the device are a prerequisite; if this is not a feasible solution
then measures to relocate the device to a clean air environment should be considered.
It is the customer's responsibility to ensure at all times that the device is protected from the harmful effects of
hostile airborne particles in the environment of the device. The manufacturer reserves the right to refuse repair
if a device has been subject to negligence, abandon or improper use.
Ambient temperature conditions
Max. ambient temperature : +40°C or 104°F
Min. ambient temperature: +0°C or 32°F
Storage temperature: -10°C to +60°C (14°F to 140°F)
Humidity Conditions
Storage: 0 to 90% relative humidity, non-condensing
Operation: 0 to 85% relative humidity, non-condensing
Environment
Do not install the device in a site near heat sources such as radiators or air ducts, or in a place subject to
direct sunlight, excessive dust or humidity. Be aware that room heat rises to the ceiling; check that
temperature near the installation site is not excessive.

3.2 Basic Workflow

Before using CX-50
1. Unpack the ClickShare components and accessories from the box.
For a detailed overview of the content of the CX-50 box, see "About the CX-50 ", page 24.
2. Install the Base Unit in the meeting room using one of the 2 possible installation methods.
For more information on the installing procedures, see "Installation methods for the Base unit", page 32
3. Connect the video signal between the Base Unit and the display, see "Video signal connections to the Base
unit", page 35.
4. Connect audio devices via USB, jack or SPDIF if any to the Base Unit, see "Content Audio connection", page
36 or see "Echo Canceling Speakerphone audio connection", page 37.
5. Connect USB camera to Base Unit if any, see "Camera connection", page 36
6. Connect the Base Unit to the mains power.
For more information see "Power connection", page 38,
7. Connect a network cable between the Base Unit and the local network (make sure the Base Unit is connected
to the internet to be able to reach the update server )
8. Register you device, online or offline.
For more information on using CX-50 , refer to the CX-50 User Guide. This manual can be found on
Barco's website www.barco.com/clickshare.
30 R5900096 /00 CX-50