Wired Roomdock - Barco CX-50 Gen2 Installation Manual

CX-50 Gen2 Installation
Via USB and display
1. Connect the USB Type-C port at the backside of the Base Unit to the USB input of the display (only for
displays that can deliver power to the USB port)
Minimum power specification for the USB of the display are: 90W or 100W (20V/5A or 20V/4.5A)
Image 4–12
The display sends power to the Base Unit and the Base Unit sends video signal to the display.

4.19 Wired roomdock

About wired roomdock
The front USB Type-C
With wired roomdock, the user can share high resolution and frame rate content and connect to the room
audio and video over a wired connection.
How to connect
1. Make a connection between the laptop USB Type-C
Unit (can also with the USB Type-C
Note: Make sure that the laptop USB Type-C
44 R5900120 /01 CX-50 Gen2
TM port supports the wired roomdock functionality.
TM port on the Barco HDMI-in to USB-C convertor)
TM port and the front USB Type-C
TM port supports display port alternate mode.
TM port of the Base