Table of Contents
Advertisement
CX-50 Gen2 Configurator
When SmartCare is activated, in the SmartCare pane the message SmartCare active, valid until... is
displayed.
When not yet activated, you have 6 months after the first setup to activate SmartCare and enjoy 5 years of
hardware coverage.
When the activation period is expired, the warranty end date will be displayed.
6.38 Firmware Update
About Firmware update
The firmware of the Base Unit can be updated via the web interface. The latest version of the firmware is
available on Barco's website.
Image 6–58 Firmware update
About automatic firmware updates
There are 3 ways to configure automatic updates:
•
Automatic: The system will automatically detect firmware updates and install them for you when it's not in
use.
•
Notify: The system will automatically detect firmware updates and notify you on the web interface
dashboard and firmware page. The update can then be initiated via the Support & Updates > Firmware
page
•
Off: The system will not detect firmware updates and will not notify you.
Manual firmware update
1.
Download the latest version of the firmware from Barco's website.
2.
Log in to the Configurator.
3.
Click Support & Updates → Firmware.
4.
To upload a firmware version, click on Upload firmware...
A browser window opens.
5.
Browse to the file with the new firmware and click Open to start the upload.
Note: This should be an .enc file. You might have to unzip the file downloaded from Barco's
website.
114
R5900120 /01
CX-50 Gen2
Advertisement
Chapters
Table of Contents
Troubleshooting
