Barco CX-50 Gen2 Installation Manual page 22

CX-50 Gen2 Specifications
USB Type-C TM Port
The front USB Type-C
the software and firmware of both the Base Unit and the Buttons.
The front USB Type-C
input. This port supports the wired roomdock functionnality. With wired roomdock, the user can share high
resolution content and connect to the room audio and video over a wired connection.
The back USB Type-C
echo-cancelling speakerphone to the Base Unit. It can also be used as power input via USB.
Status LED ring
The color of the LED ring around the power button of the Base Unit give information on the status of the
system.
LEDs behavior
static red
blinking white
breathing white
static white
red blinking
dark
Power button
The button at the front of the Base Unit has a standby function once the Base Unit is powered.
• When the system is in normal operational mode, a push makes the system goes into a pre-defined standby
mode.
• When the system is in standby, a push triggers the system to start up and it goes into normal operational
mode.
Back layout of the Base Unit
The connection panel is situated at the back of the Base Unit.
1
2
3
Image 2–4
22 R5900120 /01 CX-50 Gen2
TM port is used to pair the Button to the Base Unit. This port can also be used to update
TM port used in combination with the HDMI-in to USB-C convertor, can be used as HDMI
TM port can be used to connect a second display, a touch screen, USB camera or USB
Explanation
• receiving content from the Buttons and streaming towards the
display.
• during the first phase of the Base Unit boot process.
• system is starting up (during the second phase)
• Button pairing is in progress
• software update of the Base Unit
• ECO standby mode
• awake and ready (i.e. showing the welcome message on the
display)
• pairing and software update of the Button is done, you can now
unplug the Button from the Base Unit.
• an error occurred
• deep standby/off
4
5
6
7
8