Environmental Condition Check; Security Recommendations Before Starting - Barco CX-50 Gen2 Installation Manual

Getting started

3.1 Environmental Condition Check

Environment condition check
For installations in environments where the device is subject to excessive dust, then it is highly advisable and
desirable to have this dust removed prior to it reaching the device clean air supply. Devices or structures to
extract or shield excessive dust well away from the device are a prerequisite; if this is not a feasible solution
then measures to relocate the device to a clean air environment should be considered.
It is the customer's responsibility to ensure at all times that the device is protected from the harmful effects of
hostile airborne particles in the environment of the device. The manufacturer reserves the right to refuse repair
if a device has been subject to negligence, abandon or improper use.
Ambient temperature conditions
Max. ambient temperature : +40°C or 104°F
Min. ambient temperature: +0°C or 32°F
Storage temperature: -10°C to +60°C (14°F to 140°F)
Humidity Conditions
Storage: 0 to 90% relative humidity, non-condensing
Operation: 0 to 85% relative humidity, non-condensing
Environment
Do not install the device in a site near heat sources such as radiators or air ducts, or in a place subject to
direct sunlight, excessive dust or humidity. Be aware that room heat rises to the ceiling; check that
temperature near the installation site is not excessive.

3.2 Security recommendations before starting

Keep your Base Units and Buttons up to date
Barco keeps improving their devices, this means extending existing features and adding new ones, but also
providing security patches. Therefore, it is strongly recommended to keep the Base Units up to date with the
latest available firmware, and ensure Buttons are updated. Always updating your device to the latest firmware.
Therefor, it is strongly recommended to connect your device to internet to get automatic updates.
To insure an update of all Buttons, Barco strongly recommends pairing all Buttons with the corresponding
Base Unit immediately after the Base Unit has been upgraded.
XMS platform
Manage Base Units through XMS (Cloud) management Platform to receive updates.
XMS is Barco's secure cloud-based solution for the configuration, remote management and real-time status
monitoring of your devices, distributed over different locations. Enjoy easy & automated (scheduling of)
software updates, Base Unit configuration, creation of templates, remote wallpaper installation, user
management and insights to drive Digital Workplace.
Keep Base Units locked away
In case you expect physical tampering of the hardware by malicious people Barco recommends keeping the
Base Units locked away.
Change the default Wi-Fi password
Barco strongly recommends changing the default Wi-Fi password (only applicable when WPA2-PSK mode is
used), this makes it again one step more difficult for malicious people, without physical access to your
devices, to intercept the traffic between Button and Base Unit.
26 R5900120 /01 CX-50 Gen2