Barco CX-50 Gen2 Installation Manual page 123

Problem
Low video performance
Video is not shown on screen
Some programs of Windows are
not shown on the display
When using Windows 7 the
following message about the
Windows Aero color scheme
appears: "Windows has detected
your computer's performance is
slow. This could be because there
are not enough resources to run
the Windows Aero color scheme.
To improve...".
Your screen is not shown on the
display when pressing the Button
Your content is removed from the
display and the LEDs on the button
are blinking white
Noting is shown on the displays at
all.
Cause
power USB devices when on
battery power.
Laptop performance
Wireless connectivity
Player uses overlays
Use of overlays, 3D or hardware
acceleration in the GPU
ClickShare uses resources from
the GPU. In combination with
other programs which do so,
Windows 7 sometimes shows this
message suggesting to disable
Aero to improve the performance
of your laptop.
The number of shared video'son
the screen is exceeded. When
roomdock is used, only one
participant can share his screen.
The ClickShare software is not
running.
Connection to the Base Unit is
lost.
The displays are switched off.
The display cable is not correctly
connected
The display does not recognize or
is not able to display the Base Unit
output resolution.
Troubleshooting
Solution
• Lower the screen resolution of
the laptop.
• Disable the hardware
acceleration for video.
• Use only a part of the display
to show the video.
• Right click ClickShare icon in
system tray and click on
Capture mode to toggle the
current setting..
See "Users have bad connectivity"
• Disable the usage of overlays
in the preferences of the video
player.
• video is protected by HDCP
and cannot be captured by
ClickShare.
• Disable overlays or hardware
acceleration in the GPU.
• Disable AeroGlass in Windows
7
• Upgrade the Base Unit to the
latest software version.
It is safe to ignore this message
and choose 'Keep the current
color scheme'.
Click and hold the button for 2
seconds to use the Show me full
screen function.
Go to the ClickShare drive and run
the software.
ClickShare tries to restore the
connection automatically. If it fails,
the LEDs on the Button start
blinking red.
Unplug the Button from your
laptop and try a new Button.
Switch on the displays.
Insert the display cable to the
display and the Base Unit.
Change the corresponding setting
via the web interface.
R5900120 /01 CX-50 Gen2 123