Service, Presentsense - Barco CX-50 Gen2 Installation Manual

To allow streaming (mirroring) via Google Cast, check the check box in front of Streaming via Google Cast.
To allow streaming via Miracast, check the check box in front of Streaming via Miracast.
Note: from firmware version 2.12, after a factory reset, AirPlay, Google Cast and Miracast are deactivated.
Passcode type selection
1. Log in to the Configurator.
2. Click Wi-Fi & Network → Services.
3. Click on the drop down box and select the desired passcode type.
• No passcode
• Numeric passcode
Passcode applies to all BYOD screen sharing except Google Cast.

6.22 Service, PresentSense

About PresentSense
The PresentSense function makes it easy to connect to a Base Unit when walking in meeting room. When this
function is enabled and the ClickShare desktop app is installed on the user's PC, when walking in a meeting
room the Base Unit detects via ultrasound, which contains the device ID and pin code, your presence and
makes the connection with the included pin code after the user click Connect on a popup on his PC..
The app will connect and disconnect automatically when you enter or leave the meeting room. No meeting
room selection nor entering pin codes is necessary. Only those in the room can see and hear what you do.
How to activate
1. Log in to the Configurator.
2. Click Wi-Fi & Network → Services.
Image 6–35 PresentSense
3. In the PresentSense pane, check the check box next to ClickShare presence detection via Ultrasound.
Checked: PresentSense detection activated.
Not checked: PresentSense detection not activated.
4. Select the signal strength by clicking on the drop down box next to Signal Strength.
The following options are possible:
• Low
CX-50 Gen2 Configurator
R5900120 /01 CX-50 Gen2 97