Pump Control - Siemens SITRANS L 7ML5400 Operating Instructions Manual

6.3.1.4

Pump Control

Use this wizard to configure pumps if they will be used in your application. Be sure to first
complete the applicable Quick Start Wizard.
1. Press RIGHT arrow
2. Press RIGHT arrow
3. Press RIGHT arrow
4. At each step, press DOWN arrow
item, or RIGHT arrow
5. Scroll to desired item and press RIGHT arrow
arrow
6. At any time, you can press UP arrow
Start of Wizard - Pump Control
Note
The introduction screen is displayed only on the device when using the local push buttons.
This screen is not part of the Quick Start when using SIMATIC PDM.
Shows the type of Wizard to be executed.
Options
Number of Pumps
Select the number of pumps to be used with pump control.
Options
If set to NONE, pump control is disabled.
Options
If set to NONE, pump control is disabled.
Relay Pump 1
Selects the relay assigned to Pump 1.
Options
SITRANS LUT400
Operating Instructions, 04/2021, A5E33329501-AG
to activate PROGRAM mode and open menu level 1: MAIN MENU.
two times to navigate to menu item 1.1.
to open QS Level.
to open Edit mode: the current selection is highlighted.
to continue.
CANCEL, START
NONE, 2
Default: NONE
NONE, 2
Default: NONE
RELAY 2, RELAY 3
Default: RELAY 2
to accept default values and move directly to the next
to store the change, then press DOWN
to go back, or LEFT arrow
Commissioning
6.3 Quick Start Wizards
to cancel the wizard.
75