Figure 4 Cable Connectors (Fibre Channel Tape Drive) - Quantum SuperLoader 3 User Manual

Figure 4 Cable Connectors
(Fibre Channel Tape Drive)
Quantum SuperLoader 3 User's Guide
Ethernet cable
2 Attach the other end of the Fibre Channel cable to the Fibre Channel
host.
3 Attach one end of your Ethernet cable to the Ethernet port on the
back panel of the autoloader for remote management.
4 Attach the other end of the Ethernet cable to your host network port
or router.
5 Attach the female connector of the power cable to the power
connector on the back panel of the autoloader (see figure2).
6 Plug in the power cable to the nearest properly grounded power
outlet.
7 Turn on the autoloader by setting the power switch on the back
panel to the position. Turn on any other devices you turned off
ON
earlier. Check the LCD screen to make sure the autoloader is
receiving power. If it is not, check the power connections and your
power source.
Chapter 2 Installation and Configuration
Connecting Cables
Fibre Channel cable
20