Event Error Logs (Sdlt 600 Only); A500: Hard Read Error; Table 19 Error Event Logs Field Descriptions - Quantum SuperLoader 3 User Manual

Event Error Logs (SDLT 600 only)

Table 19 Error Event Logs
Field Descriptions
Field Description
V Number The version of firmware the drive was using when the event was logged.
Date A reference date for when the firmware was created.
Time Stamp The total time in which the tape drive has had power applied to the tape drive since
the last power cycle. This is hours, minutes, seconds, and milliseconds. There is no
date associated with the power-up time.

A500: Hard Read Error

Quantum SuperLoader 3 User's Guide
These logs record basic drive events including drive errors, calibration,
and history-related actions. There are 14 event error logs, indicated by the
Event number filed, and the Event number is located on the first line. All
Event Error logs contain the same specialized fields.
In addition to the specialized fields, each Event Error log has specific
information about the cause and the suggested actions to follow for
troubleshooting errors. This information can be found in the block
descriptors of each log. To find information on specific Event Error log
entries, see:
• A500: Hard Read Error
• A501: SDLT Hard Write Error
• A502: SDLT Loader Communication Error
• A503: SDLT Drive Servo Error
• A507/A508: Directory Read Failure/Directory Write Failure
page 163
Hard Read Error is a recorded event indication the tape drive detected a
2
condition in which the drive was not successfully able to read the data
from a particular location on the media.
Event Error Logs (SDLT 600 only)
on page 152
on page 155
on page 157
on page 158
on
152