Connecting Fibre Channel And Power Cables - Quantum SuperLoader 3 User Manual

Connecting Fibre
Channel and Power
Cables
Quantum SuperLoader 3 User's Guide
4 Attach the terminator to the remaining SCSI connector on the back
panel of the autoloader (if the autoloader is the last or only device on
the SCSI bus). Otherwise, attach the cable to the next device on the
SCSI bus. Make sure that the last device on the SCSI bus is properly
terminated.
5 Attach one end of your Ethernet cable to the Ethernet port on the
back panel of the autoloader for remote management.
6 Attach the other end of the Ethernet cable to your host network port
or router.
7 Attach the female connector of the power cable to the power
connector on the back panel of the autoloader (see figure2).
8 Plug in the power cable to the nearest properly grounded power
outlet.
9 Plug in the host server or workstation and all attached devices.
10 Turn on the autoloader by setting the power switch on the back
panel to the
earlier. Check the LCD screen to make sure the autoloader is
receiving power. If it is not, check the power connections and your
power source.
During the power on self-test (POST), both LEDs are illuminated
briefly, followed by only the Ready/Activity LED flashing. When the
initialization sequence is complete, the LCD screen displays the
screen.
11 Turn on the server.
To connect the Fibre Channel and power cables to the autoloader, follow
2
these steps:
1 Attach one end of the Fibre Channel cable (included in the accessory
kit) to the Fibre Channel connector on the back panel of the
autoloader (see figure4).
Chapter 2 Installation and Configuration
position. Turn on any other devices you turned off
ON
Connecting Cables
Home
19