Quantum SuperLoader 3 User Manual page 69

Quantum SuperLoader 3 User's Guide
Fibre Channel
You can select the Fibre Channel parameters from On-board Remote
Management.
In a native Fibre Channel device, dynamic World Wide
Note:
Naming is supported.
To select the Fibre Channel parameters:
1 From any page, click the
screen displays.
2 Under
System Operations
3 Under
Fibre Channel
• Auto Negotiate
• Peer to Peer
• Loop
• Loop ID
4 Under
Fibre Channel
• Auto Negotiate
• 1 Gig
• 2 Gig
5 Click .
submit
Note: You must perform a system reset before the changes take
effect, or you can use the front panel to power cycle your
machine.
Chapter 4 On-board Remote Management
heading. The
Configurations
, select
Fibre Channel
, select the desired
Topology.
, select the desired
Speed
Configurations Page
Configurations
.
.
4
51