Sequential Mode Operations - Quantum SuperLoader 3 User Manual

Sequential Mode
Operations
Quantum SuperLoader 3 User's Guide
• To modify the change mode, scroll to the mode to which you
want to set the autoloader and press
appears on the LCD.
mode
4 Press and hold the power button on the front panel until
Shutdown wait 60 sec
LCD and the autoloader shuts off.
5 Press the power button again to power up the autoloader. The new
change mode is now in effect.
If you enable
Sequential
5
under the
Commands
• The command allows you to load the first cartridge.
Start
• The
Resume
slot, if a user stopped the cycle.
• The command allows you to stop the cycle.
Stop
To start
Sequential
1 From the main menu, scroll to
2 From the
Commands
.
Enter
3 From the
Sequential Ops
Moving first tape to drive
To stop
Sequential
1 From the main menu, scroll to
2 From the
Commands
.
Enter
3 From the
Sequential Ops
Ejecting tape from drive
To resume
Sequential
1 From the main menu, scroll to
2 From the
Commands
.
Enter
3 From the
Sequential Ops
.
Enter Moving next tape to drive
appears on the LCD.
mode, you must use the
menu to operate the autoloader after you reboot.
command allows you to continue from the next unused
mode operation:
Commands
menu, scroll to
menu, scroll to
appears on the LCD.
mode operation:
Commands
menu, scroll to
menu, scroll to
appears on the LCD.
mode operation:
Commands
menu, scroll to
menu, scroll to
appears on the LCD.
Chapter 5 Administration
Setting the Change Mode
.
Enter Reboot to enable new
System
appears on the
Power Off
Sequential Ops
, and then press
, and then press
Sequential Ops
, and then press
Start
, and then press
, and then press
Sequential Ops
, and then press
Stop
, and then press
, and then press
Sequential Ops
, and then press
Resume
submenu
.
Enter
.
Enter
.
Enter
.
Enter
.
Enter
77