Quantum SuperLoader 3 Manual

Preparing to Replace the SuperLoader 3 Rackmount
Safety Precautions
© 2013 Quantum Corporation. All rights reserved. Quantum, the Quantum logo, DLT, DLTtape, the DLTtape logo, SuperLoader,
Scalar, DXi, StorageCare, StorNext, GoProtect, and Vision are registered trademarks of Quantum Corporation and its affiliates
in the United States and/or other countries. All other trademarks are the property of their respective owners. Quantum
specifications are subject to change.
6-68061-01 Rev A, December 2013
Quantum SuperLoader 3:
Rackmount Replacement
Follow the steps in the document to replace a rackmount for your
SuperLoader 3:
To replace the rackmount, refer to the following sections:
• Preparing to Replace the SuperLoader 3 Rackmount
• Removing the SuperLoader 3 from the Rackmount
• Replacing the SuperLoader 3 In a New Rackmount
• Completing the Installation
Note: Read this entire document before beginning any of the procedures.
Before beginning a rack mount installation, complete the following safety
precautions:
1 Lower the cabinet feet.
2 Extend the cabinet anti-tip device, if available.
3 Ensure that the cabinet and all rack mounted equipment have a reliable
ground connection.
4 If you have made any changes to the location of your SuperLoader 3, verify
that the total current of all rack mounted components (including the
on page 12
*6-68061-01*
on page 1
on page 4
on page 10