Introduction - Quantum SuperLoader 3 User Manual

Introduction

Quantum SuperLoader 3 User's Guide
When you first power on the Quantum SuperLoader 3 autoloader, it
automatically runs a power on self-test (POST). During the POST, the left
(green) LED flashes. After the POST, the left (green) and right (amber)
LED flash alternately back and forth. Do one of the following:
• If the autoloader powers on successfully, continue configuring the
autoloader (see Configuring the
Note: The front panel requires a six-digit password to change the
configuration (see
LCD front panel default password for the Administrator is
. The default password for the Operator is
000000
• If the autoloader does not power on successfully, check the following:
• Power switch is on.
• Power cable is inserted correctly.
• SCSI (or SAS, or Fibre Channel) cable is connected to the
autoloader and host computer.
• SCSI bus is terminated (SCSI autoloader).
• No error code displays on the autoloader LCD.
• If you cannot resolve the problem yourself, contact your service
representative or go to www.quantum.com.
When you first power on the autoloader, the setting for the Internet
Protocol (IP) address is static with the address
to use Dynamic Host Configuration Protocol (DHCP) to change the IP
address, see "Setting the IP Address"
address when using DHCP, view the Ethernet status information (see
"Viewing Ethernet Information"
Chapter 5 Administration
Autoloader).
"Setting Passwords"
192.168.20.128
on page 72. To determine the IP
on page 45).
Introduction
on page 79). The
.
111111
. If you want
67