Setting Ethernet; Setting The Ip Address - Quantum SuperLoader 3 User Manual

Setting Ethernet

Setting the IP Address

Quantum SuperLoader 3 User's Guide
Ethernet is the method used by the autoloader to access a network. With
an Ethernet connection, you can remotely access the autoloader over the
network. To use the Ethernet connection, you must define the following:
• A dynamic or static IP address for the autoloader (required)
• A subnet mask (required)
• An IP gateway (optional)
• A Simple Network Management Protocol (SNMP) server (optional)
• A time server, or set the time and time zone manually (optional)
An IP address is the address of any device attached to a network. Each
5
device must have a unique IP address. IP addresses are written as four
sets of numbers separated by periods ranging from
including
255.255.255.255
IP addresses are either permanent or dynamically assigned. A
permanent, or static, address remains the same each time the device
connects to the network. A dynamic address may change each time the
device connects to the network server using Dynamic Host Configuration
Protocol (DHCP).
To set a dynamic IP address:
1 From the main menu, scroll to
2 From the
Configuration
3 From the
Ethernet
4 Scroll to
DHCP
displays on the LCD screen.
5 Press and hold the power button on the front panel until
Shutdown wait 60 sec
LCD, then the autoloader shuts off.
6 Press the power button again to power on the autoloader. The IP
address is changed.
.
Configuration
menu, scroll to
submenu, scroll to
, and then press
Enter
displays on the LCD.
Chapter 5 Administration
Setting Ethernet
up to and
0.0.0.0
, and then press
, and then press
Ethernet
, and then press
Set IP
.
Please reboot to use DHCP
displays on the
Power Off
.
Enter
.
Enter
.
Enter
System
72