Configuring The Autoloader - Quantum SuperLoader 3 User Manual

Configuring the Autoloader

Quantum SuperLoader 3 User's Guide
To configure the autoloader, start with the main menu on the front panel.
If the main menu is not already visible on the LCD, press
When you first power on the autoloader, the default is set with no
password protection. However, after you set the security option, all the
configuration functionality is password-protected. You need an
administrator-level password to configure the autoloader.
To configure the Quantum SuperLoader 3 autoloader, you must verify
the setup of the following:
• SCSI, SAS, or Fibre Channel autoloader.
• Magazine(s).
• Ethernet IP address (if you are not using DHCP).
• Time zone, date, and time.
• Control mode.
• Security option.
The front panel menu provides the following options (see
Chapter 5 Administration
Configuring the Autoloader
.
Enter
figure 8):
68