Bugcheck Error Logs (Sdlt 600 Only) - Quantum SuperLoader 3 User Manual

ASC/ASCQ Description
14/00
Entity Not Found
was written on the tape was not
found while trying to read the data.
47/00
SCSI Parity Error
communications problem.
80/01
Cleaning Required
detected a condition in which a
cleaning tape must be used. (SDLT)

Bugcheck Error Logs (SDLT 600 only)

Quantum SuperLoader 3 User's Guide
. A logical block that
. SCSI bus
. The drive has
Bugcheck Error logs typically indicate that the firmware has reached a
point in the decision process that requires a drive reset. There are 11
bugchecks, indicated by the Bugcheck Error field found in the event log's
first line. The following conditions may cause a bugcheck:
• Hardware errors
• Media errors
• Power supply problems
• External conditions (shock, vibe, hot, cold, and so on)
• Firmware problems
Typically, firmware problems are not the cause and
Note:
you should check for other sources. If it is determined
to be a firmware issue, contact customer support.
Bugcheck Error Logs (SDLT 600 only)
Suggested Action
• Problem may be the tape cartridge or the
drive. Check drive logs to correlate events that
may have led up to this condition.
• If the problem continues, contact customer
support.
• Check SCSI cables, terminators, and all
devices attached to the SCSI bus.
• Use a cleaning tape and/or different media.
Check drive logs to review related events. If
this persists with multiple media after
cleaning, the drive may need to be replaced. If
all related to one piece of media, replace that
tape cartridge.
• If the problem continues, contact customer
support.
150