General Preparation For Rack Mount Installation; Stationary Rack Mount Installation - Quantum SuperLoader 3 User Manual

General Preparation for
Rack Mount Installation
Stationary Rack Mount
Installation
Quantum SuperLoader 3 User's Guide
Take the following general safety steps before beginning a rack mount
7
installation.
1 Lower the cabinet feet.
2 Extend the cabinet anti-tip device, if available.
3 Ensure that the cabinet and all rack mounted equipment have a
reliable ground connection.
4 Verify that the total current of all rack mounted components
(including the SuperLoader) will not exceed the current rating of the
power distribution unit or outlet receptacles.
5 Secure the help of at least one other person. At least two people are
required to safely install the SuperLoader into a rack cabinet.
Warning:
Caution:
This section describes the steps for attaching the autoloader directly to
7
the stationary rails of a rack.
1 Make sure you have the following tools and parts:
• #2 Phillips screwdriver
• Level
• The following autoloader accessory kit parts (see
• Four autoloader brackets (two long and two short to
accommodate different rack depths)
Use the short autoloader brackets (74-60604-03) unless the
distance from the front mounting rail to the rear mounting
rail is less than 30.25 in. (76.84 cm).
• Two support brackets (74-60605-01)
• Eight 10-32 x 1/4 inch button head screws for the support
brackets (four per support bracket)
Chapter 7 Customer Replaceable Units (CRUs)
Failure to take these safety steps may result in
personal injury or equipment damage.
Do not remove the top cover of the autoloader during
the installation process. Removing the top cover could
result in damage to the autoloader.
Rack Mounting the Autoloader
figure 12):
95