Changing The Barcode Scanner Setting - Quantum ATL M1500 User Manual

Changing the Barcode Scanner Setting

The
Barcode Scanner
enabled or disabled. When the scanner is enabled, the library attempts to
detect a bar code on all tape cartridge labels. If the correct bar code labels
are not used, or if some cartridges are not labeled, scanning time may be
greatly increased. Therefore, it is recommended that you disable the
option if you do not intend to use compatible bar code
Barcode Scanner
labels.
To enable or disable the
1 Access the
Configuration
Screen on page 49).
2 Press the or
Up Down
3 Press .
Select
4 Use the or
Up Down
setting. The available settings are
The default setting is
Note:
5 Press .
Select
To return to the
Configuration
setting, press
Cancel
6 Press to return to the main screen.
Main
You must reboot the library before this setting will take
Note:
effect.
ATL M-Series User's Guide
Chapter 3 Changing the Library Configuration
Changing the Barcode Scanner Setting
option controls whether the bar code scanner is
option:
Barcode Scanner
screen (see Accessing the Configuration
buttons until
Barcode Scanner
buttons to select the desired
Enabled
.
Enabled
screen without changing the option
.
is highlighted.
Barcode Scanner
and .
Disabled
3
61