Chapter 2 Operating Procedures
Operating Procedures Using the Menu Mode
Setting/Changing a Tape
Drive SCSI Address
32
Note: After changing the SCSI address of the library, one of two things must
happen to set the new SCSI ID. The host controller must issue a "SCSI
Bus Reset," or the library must be powered off and on again.
To set or change a tape drive SCSI address:
2
1 Enter the menu mode.
2 Press the SELECT button to choose the Configuration menu and
verify the following is displayed in the SDA:
M e n u : C o n f i g u r a t i
I n q u i r y
3 Use the
button to bypass the Inquiry menu and verify the
following is displayed in the SDA:
M e n u : C o n f i g u r a t i
S C S I A d d r e s s
4 Press the SELECT button again to choose SCSI Address and verify
the following is displayed in the SDA:
M e n u : S C S I A d d r e s
R o b o t i c s
button to bypass the Robotics sub-menu and verify the
5 Use the
following is displayed in the SDA:
M e n u : S C S I A d d r e s
D r i v e 0
6 Use the
and
(Drive 0, Drive 1, Drive 2, Drive 3), where:
Menu Mode Physical Location
Drive 0 =
Drive 1 =
Drive 2 =
Drive 3 =
7 With the proper drive number displayed on line #2, press the
SELECT button and verify the following is displayed in the SDA:
M e n u : D r i v e 0
S C S I I D 0
8 Use the
and
selected drive (0...7 for libraries with DLT 2000 or DLT 4000 tape
drives and 0...15 for libraries with DLT 7000 tape drives).
ACL 4/52 Operator's Guide
buttons to navigate to the proper drive number
Top Drive
Second Drive
Third Drive
Bottom Drive
buttons to navigate to the SCSI ID number for the