Chapter 3 Changing the Library Configuration
Changing the Off-Line Time Setting
Changing the Off-Line Time Setting
60
5 Press
.
Select
To return to the
Configuration
setting, press
Cancel
6 Press
to return to the main screen.
Main
When you access the
NOT READY and will not respond to any SCSI commands issued. If you
leave the library unattended in menu mode, the library goes back to a
READY state after a pre-set time-out, controlled by the
option. You can set this time-out to any value from 1 to 99 minutes, or
turn it off.
To set the
Off-Line Time
1 Access the
Configuration
Screen
on page 49).
2 Press the
or
Up
Down
3 Press
.
Select
4 Use the
or
Up
Down
The available settings are
The default setting is
Note:
5 Press
.
Select
To return to the
Configuration
setting, press
Cancel
6 Press
to return to the main screen.
Main
ATL M-Series User's Guide
screen without changing the option
.
screen using the GUI, the library becomes
Menu
:
screen (see
Accessing the Configuration
buttons until
Off-Line Time
buttons to select the desired
through
1
99
Disabled
screen without changing the option
.
Off-Line Time
is highlighted.
Off-Line Time
and
.
Disabled
.
3
setting.