Running The Demo 5 Program - Quantum ATL M1500 User Manual

Running the Demo 5 Program

The program causes the robot to pick a randomly selected
Demo 5
cartridge from its magazine slot and place it in another magazine slot on
another level of the stacked library. This test maximizes the use of the
StackLink.
This program is for multiple library stacks only.
Note:
To run the program:
Demo 5
1 Verify that at least:
• Two library modules are installed in the stack
• One magazine is installed in each library module
• One cartridge is present
2 Access the
Demo Programs
Screen on page 93).
3 Press the or
Up Down
4 Press .
Select
The program starts. This program continues until you press
Demo 5
the button.
Stop
5 To stop the program, press
The GUI displays a status screen listing the demonstration program
number, the number of cycles completed, and the status of the test:
pass or fail.
6 Press to return to the
Back
ATL M-Series User's Guide
Chapter 7 Running the Demonstration Programs
Running the Demo 5 Program
screen (see Accessing the Demo Programs
buttons to select
Demo 5
.
Stop
Demo Programs
.
screen.
7
99