Running The Move Location Test - Quantum ATL M1500 User Manual

Chapter 5 Running Diagnostic Programs

Running the Move Location Test

Running the Move Location Test
84
15 Repeat steps 13 and
number is displayed.
Setting the cycle count to
Note:
continuously.
16 Press until the cursor is all the way to the right and the
Right
button appears.
17 Press to set the cycle count, or press
Select
screen without running the
Diags: General
The test starts and the GUI displays a
stops automatically after completing the selected number of cycles.
When the test is complete, the GUI displays a screen indicating the
test status.
To abort the test before it completes the selected number of cycles,
press .
Stop
18 Press .
Back
The GUI displays the cycle count screen.
19 Press , then
Cancel
The test is similar to the
Move Location
cartridges are actually moved.
When the
Move Location
from its current location to the destination location.
When the
Move Location
repeatedly moved between the destination location and a home location,
and will return to the home location at the end of the selected number of
ATL M-Series User's Guide
14 as necessary until the desired cycle count
0000
Running Diag
to return to the
Back Diags: General
Move Medium
test is cycled once, the robotic hand is moved
test is cycled more than once, the robotic hand is
causes the test to run
Select
to return to the
Cancel
test.
Move Medium
screen. The test
screen.
test, except that no
5