Running The Demo 1 Program - Quantum ATL M1500 User Manual

Running the Demo 1 Program

The program causes the robot to pick a randomly selected
Demo 1
cartridge from its magazine slot and place it in another randomly selected
magazine slot.
To run the program:
Demo 1
1 Verify that at least one magazine is installed in the library and that at
least one cartridge is present.
2 Access the
Demo Programs
Screen).
3 Press the or
Up Down
4 Press .
Select
The program starts. This program continues until you press
Demo 1
the button.
Stop
5 If desired, include the drives or the fixed slot in the test:
If the library is an ATL M1500 in a multiple library stack or an
a
ATL M2500, press the
desired drive or fixed slot is located.
Press
b
Drive 1
Press to include the fixed slot.
c
Fixed
6 To stop the program, press
The GUI displays a status screen listing the demonstration program
number, the number of cycles completed, and the status of the test:
pass or fail.
7 Press to return to the
Back
ATL M-Series User's Guide
Chapter 7 Running the Demonstration Programs
screen (see Accessing the Demo Programs
buttons to select
Demo 1
button to select the level where the
Level
or to include a drive.
Drive 2
.
Stop
Demo Programs
Running the Demo 1 Program
.
screen.
7
95