Leak Detection - TESTO 330-1G Instruction Manual

1.800.561.8187 1.800.561.8187
6.2.16.4.

Leak detection

In gas leak detection no measurement is made, but a gas detection
is performed.
✓ A gas leak probe (0632 3330) must be connected.
You must also refer to the documentation that comes with
the gas leak probe.
Calling up the function:
> Leak Detection→ [OK].
Performing the detection:
> Set the gas type to be detected and perform gas leak testing by
following the instructions described in the documentation of the
gas leak probe.
1. Start detection:
- The gas concentration is displayed, if it exceeds the limit an
alarm signal will sound.
Options:
> [Options] → Save: the readings are saved in a record.
> [Options] →
form of a line graph.
> [Options] →
a measurement): Adjusting alarm limits.
[Options]
> →
during a measurement): Alarm signal disable/enable.
> [Options] →
> [Options] →
detected.
2. End detection:
www. www.
[ ].
Show Graphic: The readings are displayed in
Alarm Limit: (This function is not available during
Alarm Signal: (This function is not available
Zeroing Probe: Perform zeroing.
Sensor detection: newly inserted sensor is
[ ].
.com .com
6 Using the product
67
information@itm.com information@itm.com