Let By Test; Leak Detection - TESTO 330 Instruction Manual

6 Using the product
- The stability time will run. After this the measuring phase starts
automatically.
> End stability time and measurement early: [Next].
- The readings and
measurement has been completed.
7. [Edit]
6.2.15.3.

Let By Test

> Insert the connector plug of the pressure test kit (0554 1213)
onto the flue gas socket and lock by slightly turning it clockwise
(bayonet lock).
Performing the measurement:
✓ The pressure socket of the instrument must be free (i.e.
unpressurized, not closed).
1. Let By Test
- Pressure zeroing.
2. Select parameter: [▲],
3. Set parameters or enter values: [▲],
[OK].
4. Pressurise the system.
5. Start measurement:
- The stability time will run. After this the measuring phase starts
automatically.
> End stability time and measurement early: [Next].
- The readings and
measurement has been completed.
6. [Edit]
6.2.15.4.

Leak detection

In gas leak detection no measurement is made, but a gas detection
is performed.
✓ A gas leak probe (0632 3330) must be connected.
Calling up the function:
> Leak
58
Result Tightness Test 2
→ Select test result: [▲],
→ [OK].
[
Result Let By Test
→ Select test result: [▲],
You must also refer to the documentation that comes with
the gas leak probe.
Detection→ [OK].
→ [OK].
[▼]
→ [Edit].
[▼]
[▼]
].
are displayed when
→ [OK].
[▼]
are displayed when
and partly [◄], [►]→