Oil Flow Rate; Leak Detection - TESTO 330-1 Instruction Manual

G. Measuring
42
G.2 Measurements
G.2.10 Oil flow rate
The

Oil flow rate

Calling up the function:
Measurements
Measuring:
1 Enter the flow rate:
2 Enter the oil pressure:
- The calculated oil burner output is displayed.
3 Copy the values to the
- The
Measurements
G.2.11 Leak detection
Gas is detected during leak detection; the gases are not measured.
A gas leak probe (0632 3330) must be connected.
Please refer to the documentation enclosed with the gas leak probe.
Calling up the function:
Measurements
Measuring:
Carry out the setting for the gas to be detected according to the instructions found in
the documentation for the gas leak probe.
- The gas concentration is shown in a graph (trend display).
- An alarm message is given if the alarm threshold is exceeded.
Set alarm threshold: see Alarm limits , p. 29.
function is only available if the activated fuel is an oil.
OK Oil flow rate
Flow rate
Oil pressure
menu:
Flue gas
menu is opened.
OK

Leak detection

.
OK
Enter the value
Change
Enter the value
Change
OK Copy readings
.
OK
.
OK
.
OK
.
OK