Configuring The Reading Display; Setting Location And Fuel - TESTO 330-1G Instruction Manual

1.800.561.8187 1.800.561.8187
The tip of the probe must be in the hot spot of the flue gas flow.
> Align the flue gas probe in the flue gas duct so that the tip is in
the hotspot (area of the highest flue gas temperature). As a
visual aid, the display shows the current temperature with a
green bar. The red marking indicates the maximum measured
temperature during the hotspot search. If the
appears, the temperature is outside the measuring range of the
flue gas probe.
The measuring value of the red marking and the
symbol can only be cancelled by restarting the flue gas
menu.
6.2.1.3.

Configuring the reading display

Only those parameters and units, which are activated in the reading
display, appear in the reading display, the saved measurement
protocols and the record printouts.
> Before performing measurements set up the reading display in
such a way, that the required parameters and units are
activated, see Readings display, page 39.
6.2.1.4.

Setting location and fuel

Before carrying out measurements, the measurement location and
the fuel must be correctly selected, see Address/Location, page 34
and Fuels, page 48.
www. www.
6 Using the product
symbol
information@itm.com information@itm.com
.com .com
51