6.2.15.4.
Leak detection
In gas leak detection no measurement is made, but a gas detection
is performed.
✓ A gas leak probe (0632 3330) must be connected.
Calling up the function:
>
Leak
Performing the detection:
> Set the gas type to be detected and perform gas leak testing by
following the instructions described in the documentation of the
gas leak probe.
1. Start detection:
-
The gas concentration is displayed, if it exceeds the alarm limit
an alarm signal will sound.
Options:
>
[Options]
form of a line graph.
>
[Options]
a measurement) Adjust alarm thresholds.
>
[Options]
during a measurement) Disable/enable alarm signal.
>
[Options]
2. End detection:
Pos: 76 /TD/Produkt verwenden/testo 330/testo 330 Überschrift Daten übertragen @ 6\mod_1279258550805_7011.doc @ 66605 @ 2
6.3.
Transferring data
Pos: 77 /TD/Produkt verwenden/testo 330/testo 330 Daten übertragen @ 6\mod_1279258680964_7011.doc @ 66636 @
6.3.1.
Protocol printer
To be able to transmit data via infrared or Bluetooth interface to a
Testo protocol printer, the printer to be used must have been
enabled, see Printer, page 36.
Printing out data takes place via
only available if a printout is possible.
You must also refer to the documentation that comes with
the gas leak probe.
Detection→ [OK].
[
].
→
Show
Graphic: The meas. views are displayed in
→
Alarm
Limit: (This function is not available during
→
Alarm
Signal: (This function is not available
→
Zeroing
[
].
Probe: Perform zeroing.
[Print]
oder
6 Using the product
[
]. The function is
59