Leak Detection - TESTO 330 Instruction Manual

6.2.16.4.
d Quality Products Online at:

Leak detection

In gas leak detection no measurement is made, but a gas detection
is performed.
✓ A gas leak probe (0632 3330) must be connected.
You must also refer to the documentation that comes with
the gas leak probe.
Calling up the function:
> Leak Detection→ [OK].
Performing the detection:
> Set the gas type to be detected and perform gas leak testing by
following the instructions described in the documentation of the
gas leak probe.
1. Start detection: [
- The gas concentration is displayed, if it exceeds the limit an
alarm signal will sound.
Options:
[Options] → Save: the readings are saved in a record.
>
[Options] Show
> →
form of a line graph.
> [Options] → Alarm
a measurement): Adjusting alarm limits.
[Options] Alarm
> →
during a measurement): Alarm signal disable/enable.
> [Options] → Zeroing
> [Options] → Sensor
detected.
[
2. End detection:
GlobalTestSupply
www.
].
Graphic: The readings are displayed in
Limit: (This function is not available during
Signal: (This function is not available
Probe: Perform zeroing.
detection: newly inserted sensor is
].
6 Using the product
67
.com
sales@GlobalTestSupply.c