Leak Detection - TESTO 320 Instruction Manual

info@Testo-Direct.com
2. Enter values. [▲],
3. Start measurement:
4. End measurement:
- The ambient CO2 value is displayed.
Options:
> [Options] → Clipboard: data is saved to the clipboard.
> [Options] →
is deleted.
> [Options] → Save: the measured values are saved in a record.
> [Options] →
> [Options] → Edit: values for adjustable parameters can be
edited.
> [Options] →
during a measurement) The measured value display menu is
opened.
6.2.16.

Leak detection

This function is not available when the
selected.
During gas leak detection, no measurement is carried out, but gas
detection is performed.
✓ A gas leak probe (0632 3330) must be connected.
You must also refer to the documentation that comes with
the gas leak probe.
Call up function:
> [ ] → Measurement options
→ [OK].
Carrying out detection:
> Set the gas type to be detected and perform gas leak testing by
following the instructions described in the documentation of the
gas leak probe.
1. Start detection:
- The gas concentration is displayed, and if it exceeds the limit,
an alarm signal will sound.
Options:
[Options] → Save: the readings are saved in a record.
>
> [Options] →
measurement) Adjusting alarm limits.
www.
[▼] and in some cases [◄],
[ ].
[ ].
Delete clipboard: any data saved to the clipboard
Alarm limit: the alarm limits menu is opened.
Measurement view: (This function is not available
Spain
country version is
→ [OK] →
[ ].
Alarm limit: (this function is not available during a
Testo-Direct
6 Using the product
[►] → [OK].
Gas leak detection
57
1.888.610.7664
.com