Programs; Measuring; Preparing For Measurement; Zeroing Phases - TESTO 330-1G Instruction Manual

1.800.561.8187 1.800.561.8187
6.1.5.

Programs

Five measuring programs for different measurement types can be
configured and activated. The measuring programs serve the
purpose of saving and representing measuring sequences. After
the end of the measuring process the readings of a measuring
program are automatically saved in a record.
Only one measuring program can be activated in the instrument.
Calling up the function:
> [ ] → Programs
Activating / deactivating a program:
> Select the program: [▲],
- When activating a program: The program is activated and the
measurement type matching the program is opened.
Configuring the program:
The measuring cycle takes 1s and cannot be changed.
An activated program cannot be configured.
1. Select the program: [▲],
2. Select parameters program name, measurement type, gas
phase: [▲], [▼]
3. Set parameters or enter values: [▲],
[OK].
4. Save changes: [Finished].
6.2.

Measuring

6.2.1.

Preparing for measurement

It is assumed that the contents of the chapter First steps
(see First steps, page 28) are known.
6.2.1.1.

Zeroing phases

Measuring the ambient air temperature (AT)
If no combustion air temperature probe is connected, the
temperature measured by the thermocouple of the flue gas probe
during the zeroing phase is used as the combustion air
temperature. All dependent parameters are calculated using this
value. This method of measuring combustion air temperature is
sufficient for systems dependent on ambient air. However, ensure
www. www.
→ [OK].
[▼] → [Enable] or [Disable].
[▼] → [Edit].
→ [Edit].
[▼] and partly [◄], [►]→
.com .com
6 Using the product
49
information@itm.com information@itm.com