6 Using the product
-
The stability time will run. After this the measuring phase starts
automatically.
> End stability time and measurement early: [Next].
-
The readings and
measurement has been completed.
6.
[Edit]
6.2.15.4. Leak detection
In gas leak detection no measurement is made, but a gas detection
is performed.
✓ A gas leak probe (0632 3330) must be connected.
Calling up the function:
>
Leak
Performing the detection:
> Set the gas type to be detected and perform gas leak testing by
following the instructions described in the documentation of the
gas leak probe.
-
The gas concentration is displayed, if it exceeds the alarm limit
an alarm signal will sound.
Options:
>
[Options]
>
[Options]
form of a line graph.
>
[Options]
a measurement) Adjust alarm thresholds.
[Options]
>
during a measurement) Disable/enable alarm signal.
[Options]
>
[Options]
>
detected.
72
Result Pretest
→ Select test result: [▲],
You must also refer to the documentation that comes with
the gas leak probe.
Detection→ [OK].
→ Save: the readings are saved in a protocol.
→
Show
Graphic: The meas. views are displayed in
→
Alarm
Limit: (This function is not available during
Alarm
Signal: (This function is not available
→
Zeroing
Probe: Perform zeroing.
→
Sensor
detection: newly inserted sensor is
→
are displayed when
[▼]
→ [OK].