Leak Detection - TESTO 320 Instruction Manual

> [Options]
> [Options]
edited.
> [Options]
during a measurement) The measured value display menu is
opened.
6.2.16.

Leak detection

This function is not available when the
selected.
During gas leak detection, no measurement is carried out, but gas
detection is performed.
✓ A gas leak probe (0632 3330) must be connected.
Call up function:
> [
→ [OK].
Carrying out detection:
> Set the gas type to be detected and perform gas leak testing by
following the instructions described in the documentation of the
gas leak probe.
1. Start detection:
- The gas concentration is displayed, and if it exceeds the limit,
an alarm signal will sound.
Options:
> [Options]
measurement) Adjusting alarm limits.
> [Options]
a measurement) Disable/enable alarm signal.
> [Options]
2. End detection:
→
Alarm limit: the alarm limits menu is opened.
→ Edit: values for adjustable parameters can be
→
Measurement
You must also refer to the documentation that comes with
the gas leak probe.
→
] Measurement options
[ ].
→
Alarm limit: (this function is not available during a
→
Alarm signal: (this function is not available during
→
Zeroing
[ ].
view: (This function is not available
Spain
→ →
[OK]
probe: perform zeroing.
6 Using the product
country version is
Gas leak detection
55