Reset - Button (Id Isc.prhd102-B Only) - Feig Electronic OBID i-scan ISC.PRHD102 Installation Manual

®
OBID i-scan UHF

4.1.4. Reset - button (ID ISC.PRHD102-B only)

The Reader has a reset button. Below the yellow Scan button is a small hole in the housing. Below
this is the Reset button. On the one hand you can restore the Bluetooth settings to their original
configuration on the other hand you can clear a existing "paired connection" entry.
1. Reset Bluetooth parameters of the reader to its factory settings
After activating the Reader with the Scan button the Reader is reset to its factory settings by
holding the Reset button and the Scan button down for longer than 4 seconds until the violet LED
light up.
2. Clear "paired connection" entry in internal bluetooth interface
After activating the Reader with the Scan button the "paired connection" entry in Bluetooth
interface is cleared by holding the Reset button down for longer than 4 seconds until the violet LED
light up. See also Fig. 6: Reset Time diagram.
Reset
"Bluetooth parameters"
Clear
"paired connection"
FEIG ELECTRONIC GmbH
Installation
LED
Status
ON
Reader
OFF
ON
Scan
Button
OFF
ON
Reset
Button
OFF
LED
Status
ON
Reader
OFF
ON
Scan
Button
OFF
ON
Reset
Button
OFF
Figure 6:: Reset Time diagram
Page 14 of 23
Scan - button
Reset - button
Reader
activation
Longer than 4 sec
Longer than 4 sec
Reader
activation
Longer than 4 sec
ID ISC.PRHD102
M80601-4e-ID-B.docx