Operation; Charging The Battery; Device Reset; Configuration - Feig Electronic PAN MOBILE ID ECCO Lite User Manual

IDENTIFICATION

6 Operation

Operation

6.1 Charging the Battery

Before the first operation, the main battery should be fully charged by using the included USB charging
cable. As long as the battery is charging the red LED (3) will light solid red. After the battery is fully charged
the red LED (3) turns off. A full recharge of the battery takes approx. 4 to 5 hours.
To charge the battery via USB follow the instructions below:
1. Remove the USB protection clip (9) from the device.
2. Connect the device to the USB port of a computer or to the USB power adapter (accessories).
3. As long as the battery is charging, the red LED (3) lights solid red.
4. After the battery is fully charged the red LED (3) turns off.

6.2 Device Reset

To reset the ID ECCO:Lite press and hold the keys 1, 2, 3 and 4 (see chapter 4 Product Description on page
8.) for 5 seconds.
 NOTE:
• By reset the device loses its timestamp. Before continuing to use it you must synchronize the
time settings by connecting the ID ECCO:Lite with the Master Setup. The time thereby will be
automatically synchronized with the system time of your PC.
Specific configuration settings and data will not be lost by the reset.
•

6.3 Configuration

The ID ECCO:Lite comes with preinstalled default firmware which can easily be configured to meet the
application requirements. The device function can be determined by modifying the settings in the file
"Config.ini" which is stored on the device memory or using the PC software tool "Master Setup" which is
available for download from www.panmobil.com.

6.3.1 Config.ini Configuration

To configure the ID ECCO:Lite connect the device to your PC by using a mini USB to USB-A cable. The
device will automatically power ON after 2 seconds when the device is connected to the PC. Browse the
removable drive "SCANNDY" and open the file "Config.ini" with the text editor.
[General]
PwrOffDelay=0
Set the timeout in minutes you want the device to power off when it is not in use.
Minimum value for Batch mode = 0 minutes
Minimum value for Bluetooth mode = 3 minutes (values less than 3 will be ignored)
LeftKeyText="LEFT"
Set the static data you want to be saved or sent by Bluetooth if key 3 is pressed for 4 seconds.
MiddleKeyText="MIDDLE"
Set the static data you want to be saved or sent by Bluetooth if key 2 is pressed for 4 seconds.
ID ECCO:Lite 6 Operation
Page 12 of 23