Reader With Usb-Interface Id Isc.prhd102-Usb - Feig Electronic OBID i-scan ISC.PRHD102 Installation Manual

®
OBID i-scan UHF Installation ID ISC.PRHD102

4.2. Reader with USB-interface ID ISC.PRHD102-USB

The power supply follows though the USB-interface (Bus-powered)
The USB-interface must support a current of 500mA (High Powered Interface)
The data rate of the reader is reduced to 12 Mbit (USB high speed).
The reader dispose of a fixed connected interfaces cable with standardized USB-connector. The
Reader must only be connected to the USB-port of the PC.
If the reader is used for the first time, it must be registered in the operating system of the computer.
For this the instruction "M30100-xde-ID-B: Installation of the OBID USB driver" can be used
FEIG ELECTRONIC GmbH Page 16 of 23 M80601-4e-ID-B.docx