Editing The Measurement Data Memory - wtw Avantor VWR pH 1100 L Operating Manual

pH 1100 L
Energy saving mode
([Eco mode])
Terminating the
automatic storage
function prematurely
Editing the data memory
ba77068d05 05/2021
If the automatic storing function is active, the meter provides an energy
saving mode ([Eco mode]) to avoid unnecessary energy consumption.
The energy saving mode switches off functions of the meter that are not
required for the automatic storage of measurement data (such as the
display). By pressing any key the energy saving mode is switched off
again.
Proceed as follows to switch off the automatic data storage function
before the adjusted storage duration has expired:
<STR
1 Press the
The following window appears.
Warning
Stop automatic storage?
Yes
No
15.03.2014
Back
08:00
< ><
 
2 Using
The meter switches to the measured value display.
The automatic data storage function is terminated.

5.5.3 Editing the measurement data memory

The contents of the manual or automatic measurement data memory
can be shown on the display.
Each of the measurement data memories has a function to erase the
entire contents.
The contents of the manual or automatic measurement data memory
can be shown on the display and output to the interface.
Each of the measurement data memories has a function to erase the
entire contents.
The memory is edited in the menu, Storage & config/ Data storage. To
open the Storage & config menu, press the
measured value display.
_
>
key.
>
, select Yes and confirm with
Operation
<OK>
.
<F1__>
/[Menu] key in the
49